Configuring a Wireless Router as a DHCPv4 Client

In this article we will discuss Configuring a Wireless Router as a DHCPv4 Client, will make brief discussion on Configuring a Wireless Router as a DHCPv4 Client, In last article we discuss about Configuring a Router as DHCPv4 Client.

Typically, wireless routers for home or small office use connect to an ISP using a DSL or cable modem. To configure Cisco IOS DHCP, follow these steps, which include sample commands: Create a DHCP IP address pool for the IP addresses you want to use.

For example, the figure shows the default WAN setup page for a Packet Tracer wireless router. Notice that the Internet connection type is set to Automatic Configuration РDHCP. In most cases, wireless routers are set to receive IPv4 addressing information automatically from the ISP.

This selection is used when the router is connected to a DSL or cable modem and acts as a DHCPv4 client, requesting an IPv4 address from the ISP.

Add a Comment

Your email address will not be published. Required fields are marked *