EIGRP Neighbor Adjacency

In this article we will discuss EIGRP Neighbor Adjacency, will make brief discussion on EIGRP Neighbor Adjacency, In last article we discuss about The network Command.

The goal of any dynamic routing protocol is to learn about remote networks from other routers and to reach convergence in the routing domain.

Before any EIGRP update packets can be exchanged between routers, EIGRP must first discover its neighbors. EIGRP neighbors are other routers running EIGRP on directly connected networks.

EIGRP uses Hello packets to establish and maintain neighbor adjacencies. For two EIGRP routers to become neighbors, several parameters between the two routers must match. For example, two EIGRP routers must use the same EIGRP metric parameters and both must be configured using the same autonomous system number.

Each EIGRP router maintains a neighbor table, which contains a list of routers on shared links that have an EIGRP adjacency with this router. The neighbor table is used to track the status of these EIGRP neighbors.

1. A new router (R1) comes up on the link and sends an EIGRP Hello packet through all of its EIGRP-configured interfaces.

2. Router R2 receives the Hello packet on an EIGRP-enabled interface. R2 replies with an EIGRP update packet that contains all the routes it has in its routing table, except those learned through that interface (split horizon). However, the neighbor adjacency is not established until R2 also sends an EIGRP Hello packet to R1.

3. After both routers have exchanged Hellos, the neighbor adjacency is established. R1 and R2 update their EIGRP neighbor tables adding the adjacent router as a neighbor.

Add a Comment

Your email address will not be published. Required fields are marked *